Washing Machine Gearbox Problem
Washing Machine Gearbox Problem. Over time, the drive block may wear out and, in that case, your washer won’t. Here are some common causes of spin failure:
Turn off the power to the washer, disconnect the hose (have a bucket ready to catch the water), and inspect it for obstructions. The motor spins the transmission, which turns the agitator back and forth. In order to prevent any chances of leakage or electrocution, it is advised that you disconnect your washing.
Before Starting To Troubleshoot A Washing.
If the problem persists, check if something is lodged under the door. Repair clinic lists several reasons why your model of washer won't spin. Drive belt is broken or loose.
Washing Machine Not Take Softener.
If it is too hot or too cold, or if no water is coming out at all, test for. In order to prevent any chances of leakage or electrocution, it is advised that you disconnect your washing. Start the washer and run through the normal washing cycle.
If The Machine Starts And Runs In Spin, Check To See If The Disc Is Spinning.
The drive block connects the agitator to the washer transmission. Alternatively, the source of the problem could be a different component entirely. If it is, then problem is in the clutch, basket drive or the tub drive block.
The Motor Spins The Transmission, Which Turns The Agitator Back And Forth.
Raise the lid of the washer and depress any lid switch with a pen or screwdriver. The top four reasons were: This is most likely a problem with the door seal.
A Loose Or Broken Drive Belt;
When running the machine, don’t put. Washing machine not filling with water. You may be able to clear any blockages by taking it outside and.
Post a Comment for "Washing Machine Gearbox Problem"