Roper Washing Machine Won't Agitate - MUCHENH
Skip to content Skip to sidebar Skip to footer

Roper Washing Machine Won't Agitate

Roper Washing Machine Won't Agitate. After agitation stops, the washer should drain for 2 minutes without spinning. Begin by unplugging your washing machine, and then remove the top panel or cabinet.

My Roper (Whirlpool) Washer Won't Agitate Or Spin. I've Checked The
My Roper (Whirlpool) Washer Won't Agitate Or Spin. I've Checked The from www.diyforums.net

Here's how to check it. Following are some of the reasons behind your roper washer spinning issues alongside their best possible solutions. You can find the complete instructions how to remove the cabinet, the pump and the motor in the service manual.

Remove The Pump And The Motor.


The motor should then stop for a few seconds and start again. Besides, we can verify the problem by joining the functional wires together after detaching the lid switch. Following are some of the reasons behind your roper washer spinning issues alongside their best possible solutions.

Do Not Seal The Drain Hose Because It Needs Air For Water To Drain Properly.


If you’re really lucky, you might just need to reset a tripped breaker. This coupling is two drive forks made of plastic, one attached to the shaft of the drive motor, and one attached to the input shaft of the transmission. When the lid is closed a pin or projection on the lid pushes against the lid switch lever and closes the switch.

The Roper Washer Is Not Agitating.


How to inspect the lid switch in a washing machine: If your washer senses a power spike, an unbalanced load or disruption in power, it will send a fault. Roper washer agitates but won’t spin in order for clothes to be thoroughly cleaned within a roper washer, not only does the appliance need to spin, but it also needs to agitate.

It Could Be The Motor Or Possibly The Pump.


The instructions below from diyers like you make the repair simple and easy. Start the washer to see if the motor will run. There could be a clogged hose or pump, a defective lid switch, a broken drive motor, a busted belt, or bad transmission.

If The Roper Washer Works Fine, Then The Lid Switch Must Be Replaced.


It is more likely that you simply need to do a little troubleshooting to find the problem. The transmission helps move the agitator back and forth. A broken agitator is the prime suspect here.

Post a Comment for "Roper Washing Machine Won't Agitate"